View reference images
The reference image at the bottom right shows how this step should look when done. This page explains how to enlarge and compare it, and how it switches when an alarm comes.
In short
- The "Reference image" at the bottom right shows how this step should look. It changes to the image for whichever step you are on.
- Tap the card to enlarge and compare; tap anywhere to close.
If a technician has added reference images to the steps, the card at the bottom right shows "Reference image", telling you how this step should look when done.
How to use it
- Even before work starts, it shows the image for step 1. It changes to the image for whichever step you are on.
- When there are two images, "before" and "after", a small image labeled "Tap to compare" appears at the bottom right.
- Tap the card to enlarge it; the two images are shown side by side. Tap anywhere to close. When you move to the next step, the large image closes by itself.
- Some references are a short animation of a few seconds. It loops without sound.
When an alarm comes
The card does not jump to the alarm list by itself. Only the red number on the "Abnormals" tab flashes 3 times.
- To see the alarm list, tap (or swipe left or right) to it yourself.
- If you do not touch it for 20 seconds, or you move to the next step, it goes back to the reference image.
- If the current step has no reference image, this area shows only the alarm list.